Is Your Pool Leaking or Just Evaporating? The Bucket Test for Columbia, SC Pool Owners

November 13, 20265 min read

Every pool loses some water. Sun, wind and dry air pull water out of the pool every day, and Midlands summers are hard on water levels. But if you keep adding water, or your pool is dropping now that the weather has cooled off, it's fair to ask: is this a leak?

The good news is you can get a solid answer in 24 hours with a bucket, some tape and your own pool. It's called the bucket test, and it's the same first check we use before any pool leak detection job in Columbia, Lexington, West Columbia and the rest of the Midlands.

Why the bucket test works

Water in a bucket can only leave one way: evaporation. Your pool can lose water through evaporation and through a leak. If you set a bucket of pool water on your pool step, both get the same sun, wind and temperature. After a day, compare the two. If the pool dropped more than the bucket, the extra water went somewhere else.

What you need

  • A clean 5-gallon bucket
  • Duct tape or a waterproof marker
  • A pool step where the bucket can sit without tipping
  • 24 hours with no rain in the forecast and nobody swimming

How to do the bucket test, step by step

  1. Set the pool to its normal level. About the middle of the skimmer opening. Don't overfill it.
  2. Turn off the autofill if your pool has one. An autofill can hide a leak by quietly topping the pool off.
  3. Fill the bucket with pool water so the water inside is close to the pool level when it sits on the step.
  4. Set the bucket on the first or second step so most of it is under water. Add a brick inside if it wants to float.
  5. Mark the water level inside the bucket with tape or a marker.
  6. Mark the pool level on the outside of the bucket (or on the skimmer).
  7. Leave everything alone for 24 hours. No swimming, no adding water, no moving the bucket.
  8. Measure both drops and compare them. Take a photo of each mark. It helps if you call us.

Reading your results

What you see after 24 hours What it likely means What to do
Pool and bucket dropped about the same Normal evaporation Keep an eye on it
Pool dropped noticeably more than the bucket Likely a leak Schedule leak detection
Results are close or unclear Inconclusive Repeat the test on a calm, dry day
It rained during the test Test is not valid Start over

A common rule of thumb among leak detection companies: if the pool drops about a half inch or more beyond the bucket in 24 hours, a leak is very likely. What matters is the difference between the pool and the bucket, not how many inches the pool lost by itself.

Bonus: run it twice to narrow down where the leak is

Do the test once with the pump off and once with the pump running its normal schedule.

  • Pool loses more with the pump running: the leak may be on the pressure side of the system, like a return line, or at the equipment pad.
  • Pool loses more with the pump off: the leak may be on the suction side (skimmer or main drain line), or in the shell, liner or a fitting.
  • Same loss either way: often the shell, liner, light niche or a fitting.

This doesn't pinpoint the leak, but it gives us a head start and can save time on the visit.

Why fall is a good time to check

Many Columbia-area pools get closed or run less in November. Cooler weather means less evaporation, so a leak is easier to see. And a leak you leave over the winter keeps washing out soil under the deck and pool. If your pool is closed and still dropping below the skimmer, that's worth a call before spring.

Easy-to-miss spots to look at while you wait

  • Wet ground, soft spots or extra-green grass between the pool and the equipment pad
  • Drips or wet areas around the pump, filter and heater
  • Cracks where the skimmer meets the deck
  • Loose tile, cracks in the plaster, or a vinyl liner pulling away at the edge
  • Air bubbles in the return jets or a pump that won't stay primed

When the bucket test says "leak"

That's where we come in. The Leak Geeks is a Leaktronics Certified pool leak detection company based in West Columbia. On a typical visit we:

  1. Measure and confirm the water loss
  2. Dye test the shell or liner and every fitting
  3. Pressure test each pool line
  4. Pinpoint underground leaks with Leaktronics electronic listening equipment
  5. Repair what we find: skimmer, liner patch, fitting, or no-dig pipe repair through Pipepoxy

If a buried pipe is the problem, we can often line it from the inside with Pipepoxy no-dig pool pipe repair, so your deck stays in one piece.

Did the bucket test point to a leak? Call or text 803-570-5283, any time, 24/7. Same-day appointments are often available in Columbia, Lexington, West Columbia, Irmo, Forest Acres and nearby. Learn more about our pool leak detection service or, for vinyl pools, vinyl pool leak detection.

Frequently asked questions

How long should a pool bucket test take? 24 hours. Check it as close to the 24-hour mark as you can. If it rains, start over.

Do I turn the pump off for the bucket test? For the basic test, yes. Running a second test with the pump on can help show whether the leak is in the pool lines or the pool itself.

Can I do the bucket test on a vinyl liner pool? Yes. It works the same on vinyl, gunite and fiberglass pools.

My pool is closed for the winter. Can it still leak? Yes. If the water keeps dropping below the skimmer while the pool is closed, have it checked before spring so the leak doesn't keep washing out the soil under the pool.

What if my bucket test is inconclusive? Repeat it on a calm, dry day. If you still aren't sure, call 803-570-5283 and we'll walk you through it.