Slab Leak Detection in Columbia, SC

Pinpoint accuracy means less concrete comes up.

A leak under a concrete slab is the one homeowners dread, and for good reason. Water under the foundation erodes the soil supporting your house. But the fear of jackhammering the whole floor is usually unfounded, because with accurate detection the opening is often no bigger than a couple of feet square.

803-570-5283 Get a Free Quote

What You Should Know About Slab Leak Detection

Slab leaks are a real problem in the Midlands. The expansive clay soil around Columbia shifts with our wet and dry cycles, and that movement stresses the copper lines running beneath the slab until a joint or a rubbed section finally gives.

The difference between a small repair and a demolition project is entirely down to how precisely the leak is located. We isolate hot and cold lines separately, pressure test to determine which one is losing, then use electronic listening and thermal imaging to mark the spot before anything is cut.

Hot water line leaks are the most common and often the easiest to spot early, because escaping hot water warms the floor above it. If you have felt a warm patch on a tile or concrete floor, do not wait on it.

Slab Leak Detection performed by The Leak Geeks in Columbia SC

What's Included

Electronic listening for underground leaks
Line isolation and pressure testing
Thermal imaging of floor surfaces
Pinpoint accuracy minimizes excavation
Both hot and cold line detection
Clear marking so the repair opening stays small

Warning Signs

•A warm or hot spot on the floor
•The sound of running water under the floor with everything off
•Cracks appearing in flooring, tile grout or interior walls
•Unexplained spike in the water bill
•Damp or buckling flooring with no visible source
•Water seeping up along the base of an exterior wall
•Loss of hot water pressure

Recognize any of these?

Call and describe what you're seeing. We'll tell you honestly whether you need us out there.

803-570-5283

How Our Slab Leak Detection Works

A clear process, so you always know what's happening and why.

Rule out the obvious

We confirm the loss is under the slab and not a fixture, irrigation line or above-ground leak.

Isolate hot and cold

Each line is pressure tested separately to identify which side is losing water.

Listen and image

Electronic listening equipment and thermal imaging locate the leak through the concrete.

Mark the spot

We mark the exact location and explain the repair options, including whether rerouting makes more sense than cutting.

Slab Leak Detection Questions We Hear a Lot

Is a slab leak an emergency?

It should be treated as urgent. Water running under a foundation washes out supporting soil, and in Columbia clay that leads to real structural problems. It rarely gets cheaper by waiting.

Do you have to jackhammer my whole floor?

No. Detection is non-invasive, and precise location means a repair opening measured in feet rather than rooms.

What causes slab leaks around Columbia?

Mostly soil movement in our expansive clay, plus abrasion and corrosion on copper lines that have been under the slab for decades.

Will my insurance cover it?

That depends entirely on your policy. Many cover resulting damage but not the pipe itself. Our written findings give your adjuster something concrete to work from.

See All FAQs

Where We Work